re-sss

 Standalone Solar System kit  


Features

Basic Components:

  • 1 Sun Emulator (ref RE-SE)
  • 1 Battery charger (Ref RE-BCH)
  • 1 Battery bank (Ref RE-BB)
  • 1 Single phase Inverter (Ref RE-)
  • 2 Lamp Load 220V+12V (Ref RE-L)
  • 1 Resistive Load (Ref RE-)

Optional Components:

 

  • Single PV emulator
  • Multiple PV emulator
  • PV characteristics identification
  • Solar electrical parameters measurement unit (3 currents + 3 voltages, Power, energy)
  • Solar physical parameters measurement unit (irradiance, temperature).
  • Solar data acquisition (Usb or Wifi)

re-se

Sun Emulator 

The solar module rack consists of a polycrystalline solar module and a halogen spotlight as solar simulator.

Features

  • Two panels
  • Power 2x5W=10W
  • Voltage: 10,5V/21V
  • Motorized / controlled  Projector angle regulation (Sun position simulation)
  • Controlled Light  brightness (cloud simulation)
  • Series connection can be used on partial shading. 

re-pve

Photovoltaic Pannels Emulator 

RE-PVE emulates the electrical behavior of the silicon solar panel under various conditions, installation locations, and gives the freedom to perform experimentation not possible in cloudy weather

Features

  • Panel no-load voltage: 36V

  • Panel short circuit current 2.5 A
  • Irradiance and temperature of each panel can be adjusted independently.
  • Max voltage (in series): 144 V (2.5 A);
  • Maximum current (in parallel): 10A (36V);

  • Power supply: 220V

re-bch

Battery Charger

The solar charge controller monitors the charge level of the accumulator and protects this against excessive and deep depletion. To charge up the lead accumulator, the charge controller uses the IU charging processes

Features

  • Voltage : 24V/12V
  • Charge/discharge current: 10 A
  • MPP-Tracker
  • Analog or digital voltmeter and ammeter

re-bb

Battery Bank 

Protected 12V battery ​​​​​​​

Features

  • Voltage: 12V.
  • Capacity : 7AH
  • Over current protection

  • Analog or digital voltmeter and ammeter

re-1pi

Solar Single Phase Inverter 

The board consists of a commercially available off-grid inverter which generates an output voltage of 220 V AC from an input voltage of 12 V DC

Features

  • Power 500VA.
  • Input Voltage: 12V.
  • Output voltage 220V
  • Analog or digital voltmeter and ammeter

re-el

Variable elecrical load 

Resistor: 0...1 kOhm / 500 W continuously adjustable

Features

  • Power 500W.
  • Voltage: 220V/24V/12V.
  • Resistor value: 0-1Kohm
  • Analog or digital voltmeter and ammeter

re-el

Electric lamp load 

The lamp board allow the investigation and the comparison of light bulb, energy saving lamp and LED bulb

Features

  • Power 25W.
  • Voltage: 220V /24V/12V.
  • LED bulb